dynexhobby002005.jpg dynexhobby001011.jpg

Our balancing products operate in three modes;

  1. Balancing Mode

Our balancers sense the vibration level from a spinning rotor and maps the position of unbalance. Given the level of unbalance and its location Vortex can then determine what correction weight should be applied in order to achive a good balance.

  1. Vibration Spectrum Analysis Mode

This offers a unique tool to analyse the source of vibration. Our balancers sweep frequencies from as low as 10Hz up to 1500Hz. This is displayed on a graph illustrating the frequency that yields the greatest level of vibration. The frequencies leading to the highest level of vibration can then be attributed to the key sources of noise.

The Vortex can operate as a stand alone device or interface with a PC. As a stand alone device, Vortex uses the acceleromter and strobe light for balancing. When interfaced via a PC, Vortex can perform balancing as well as spectrum analysis.

  1. Oscilloscope Mode

Our balancers can also double as simple oscilloscopes. We offer a "Scope" program that simulates an oscilloscope. This can be useful when fault finding digital signals from autopilots or other controllers.
(c) Dynex Hobby 2016. All rights reserved
pasted1001.jpg
Software
pasted1001.jpg
Manuals
pasted1001.jpg
Buy
pasted1001.jpg
FAQ
pasted1001.jpg
Tutorials